1. Bolt-On Bucket Teeth Assemblies

These teeth are connected to the shank via a flex pin, and the assembly is then bolted to the bucket edge. They are designed so the tooth does not protrude below the cutting edge, allowing for smooth bucket grading.

• Standard Tooth

  • Profile: A multipurpose general-duty tooth, approximately 4.5 in. (114.3 mm) long.

  • Usage: Quick and efficient choice for general-purpose loading, hauling, and excavation ground engagement applications.

• Longer Tooth

  • Profile: A multipurpose longer forged tooth, approximately 5.5 in. (140 mm) long.

  • Usage: Shaped to increase wear life; enhances performance and efficiency for basic loading, hauling, and digging.

• Wider Edge Tooth

  • Profile: Same length as the longer tooth, but 4.0 in. wide.

  • Usage: Designed to protect bucket side edges and extend bucket life. Best for scraping, cleaning, and clearing (not intended for ground penetration).

• Tiger Tooth

  • Profile: A sharp, narrow point.

  • Usage: Ideal for applications requiring maximum penetration in severe impact digging, rock, tightly compacted soils, hard pan, clay, and frost.

• Twin Tiger Tooth

  • Profile: Twin angled points (requires 2 per bucket, installed at each end of the bucket edge).

  • Usage: Cuts a path for the bucket side in frozen, rocky ground, shale, or hard pan. Can be reversed to the opposite side once the outer point is worn to extend service life.

• Supporting Hardware:

  • Bolt-On Double Shank: Allows two teeth to be bolted for maximum penetration.

  • Bolt-On Single Shank: Allows one tooth to be bolted to the bucket edge.

  • Flex Pin: Retains the tooth on the adapter/shank.

  • Complete Bolt-On Assembly: Includes the longer forged tooth, single shank, flex pin, and hardware.

2. Weld-On Bucket Teeth Assemblies

Used primarily on excavator buckets, where the shank is welded directly to the cutting edge and teeth are secured using a roll pin.

• Standard Tooth

  • Profile: Multipurpose standard tooth, approximately 4.5 in. (114.3 mm) long.

  • Usage: Efficient general-duty tooth for basic loading, hauling, and digging.

• Tiger Tooth

  • Profile: Sharp, narrow point.

  • Usage: Delivers maximum penetration for severe impact digging, rock, clay, hard pan, and frozen ground.

• Twin Tiger Tooth

  • Profile: Two angled points (installed on the ends of the bucket edge).

  • Usage: Penetrates frozen ground, shale, and rock while clearance-cutting for the bucket sides. Reversible for extended wear life.

• Supporting Hardware:

  • Weld-On Shank: Welds to the cutting edge to hold one tooth.

  • Roll Pin: Secures the tooth onto the weld-on shank.

  • Complete Tooth Assembly: Includes weld-on shank, roll pin, and 4.5 in. standard tooth.